Issues

Search

Home > Issues > Volume19 (2009) > No.5(pp157-190)

Fe3O4 분말제조와 자기적 특성

한국자기학회지, Volume 19, Number 5, 31 Oct 2009, Pages 180-185
권우현 (건국대학교 자연과학대학 전자정보전공), 이승화 (건국대학교 자연과학대학 전자정보전공), 채광표 (건국대학교 자연과학대학 전자정보전공), 이재광 * (건국대학교 자연과학대학 전자정보전공), 서정철 (원광대학교 반도체·광디스플레이학부)
Abstract

Sol-gel 법을 이용하여 Fe3O4 분말을 합성하였으며, 합성한 분말의 구조적 특성, 입자의 모양 및 크기, 자기적 특성에 관하여 연구하였다. 두 가지의 다른 성분비 (Fe2+와 Fe3+의 몰 당량비를 1 : 2와 Fe2+ 만을 사용)와 2-ethoxyethanol 용매를 사용하여 refluxing한 후, 질소 분위기에서 200~600 oC로 열처리하여 페라이트 분말을 합성할 수 있었다. X-선 회절기를 이용하여 합성한 시료의 결정구조를 확인한 결과 두 경우 모두 250 oC 이상의 열처리로 단일상의 spinel 페라이트가 만들어짐을 확인할 수 있었다. 전계방출 주사전자현미경을 이용하여 관측한 결과에 의하면 열처리 온도가 높아짐에 따라 입자의 크기 증가를 관측할 수 있었다. Mössbauer 분광 실험에서 입자의 크기 변화에 따른 상자성체에서 준강자성체로의 전이를 관측할 수 있었다. 몰 당량비를 1 : 2의 비율로 혼합 후 250 oC에서 열처리한 분말은 크기가 상자성체와 준강자성체의 경계에 위치하며 이중 78 %의 시료는 준강자성체의 특성을 22 %의 분말은 상자성체의 특성을 가짐을 알 수 있었다. Fe2+ 이온만을 사용하는 만든 Fe3O4 분말은 200 oC의 열처리로 spinel 구조를 가지나 입자의 크기가 작아서 상자성체의 특성을 지닌다. 250 oC 이상에서 열처리한 시료는 준비 방법에 무관하게 전형적인 Fe3O4 분말의 연자성 특성을 보이고 있으며, 열처리 온도가 높아감에 따라 포화자화가 증가하고 보자력 또한 증가하는 것을 확인할 수 있었다.

Fe3O4 particles, prepared by a sol-gel method, were examined for their structural characteristic, particle shapes and sizes, and their magnetic properties. Two different chemical compositions (using a mol rate Fe2+/Fe3+ = 1/2 and only Fe2+) and 2-methoxyethanol were used for making proper solutions. And the solutions were refluxed and dry in a dry oven and the samples were fired at 200~600 oC in the N2 atmosphere. The formation of single-phased spinel ferrite powders was identified with the X-ray diffraction measurement as they were fired at above 250 oC. The result of scanning electron microscopy measurement showed the increase of annealing temperature yielded the particle size increased. The magnetic transition was observed using the Mössbaur spectroscopy measurement. As the ferrite, prepared with the chemical composition (Fe2+/Fe3+ = 1/2 ), was fired at 250 oC, 78% of the ferrite had a ferrimagnetic property and 22 % of the ferrite was non-magnetic. In case of preparing the sample with only Fe2+ and annealed at 200 oC, it had a single phased spinel structure but its particle size was too small to be ferrimagnetic. The annealing temperature above 250 oC made powders a spinel structure regardless of the preparation method. They had a typical soft magnetic property and their saturation
magnetization and coercivity became larger as the annealing temperature increased.

Keywords: 페라이트; Mössbauer 분광; 졸-젤 방법 및 자기변화; ferrite; Mössbaur spectroscopy; sol-gel method and magnetic transition
DOI: 10.4283/JKMS.2009.19.5.180